Standard Equipments :

• High strength steel for the first section, second and third are made from high strength aluminum beam.

• Pre-Piped Waterway with Electric Monitor and 1000 gpm nozzle.
  Ladder Controls at Tip of Fly & Boom Panel.

• 500 lb or 250 lb. Tip Load, Fully extended at 0 degree while flowing water at 90 degrees.

• One (1) Extension cylinders.

• UHMW polyethylene wear pads ladder slide mechanism.
  Emergency back-up Hydraulic pump.

• Rung alignment indicator
  Extension indication.

• Two-station Intercom.
  Four (4) FX-12 volt Spot and flood lights (2 at tip & 2 on base).
  Blue Strobe at Tip of Fly.

• One (1) step at tip of fly.

• Two (2) H-Type outriggers with heavy-duty superstructure is used at the rear with two (2) Down outriggers at the front .

• Auxiliary Stabiliser Pads.

• 
  All safety and locking device as per NFPA 1901.

• 
  Serrated rubber rung covering on ladder rungs.

5 year general & 20 year structural warranty

Options

• Breathing Air system including a 4500 PSI (444 cubic ft.) bottle with pressure and regulator gauge, low pressure alarm system, a Grade D air filter, and two outlets at the top of the fly section.

• Extra set of fly section steps (one set standard).

• Lifting hook.

•  Three-way Intercom with Cab Radio Interface.

• Three-way Intercom from Boom panel to tip of fly section and to pump panel control station.

• 110 or 220 AC Lights at Tip of Fly / and Outlets
  Two extra 500 watt floodlights at the tip of the fly section and at the base of the first section.

• One remote nozzle control at the pump panel station connected to collector ring swivel.

• One (1) 4” quarter-turn valve for water system, air operated.
  Electric Outrigger Controls.

• Egress at end of top fly section painted bright red.

• One limit switch to prevent accidental cab lifting, if needed.

• One indicating light provided on the Boom panel console to indicate when the aerial is aligned with the ladder bed, and can be bedded.

• Tip anchors, one on each side of the ladder.