Standard Equipments :

• 75,000 PSI Yield Material. (May be different for refurbishing ladder).

• Pre-Piped Waterway with Electric Monitor and 1000 gpm nozzle.

• Ladder Controls at Tip of Fly & Turn Table.

• 500 lb. Tip Load, Fully extended at 0 degree while flowing water at 90 degrees (May be different for refurbishing ladder).

• Extension cylinders.

• Load chart.

• Elevation angle indicator.

• Rung alignment device.

• UHMW polyethylene wear pads ladder slide mechanism.

• Emergency back-up Hydraulic pump.

• Two-station Intercom.

• Four (4) FX-12 volt Spot and flood lights (2 at tip & 2 on base).

• Blue Strobe at Tip of Fly.

• One (1) strobe light at end of base section to warn of ladder overload (Two strobes are available as an option). Regular light at the turntable control console for Refurbished Ladder is used.

• Two (2) folding steps with skid-resistant surface at tip of fly.

• Four (4) H-Type outriggers with heavy-duty superstructure. With 75’ ladder and less, Two (2) H-Type outriggers is used at the rear with two (2) “A” type outriggers at the front .

• Auxiliary Stabiliser Pads

• All safety and locking device as per NFPA 1901.

• Base section markings to show ladder extension. Number at the base of section with a lighted mirror is installed with refurbished Ladder.

• Serrated rubber rung covering on ladder rungs.

5 year general & 20 year structural warranty

Options

• Roof ladder storage on the main surface of the ladder.

• Transfer monitor to the third section, always with the use of the waterway and the ladder.

• Breathing Air system including a 4500 PSI (444 cubic ft.) bottle with pressure and regulator gauge, low pressure alarm system, a Grade D air filter, and two outlets at the top of the fly section.

• Extra set of fly section steps (one set standard).

• Eyelets for securing Safety Ropes from Tip of Fly

• Three-way Intercom with Cab Radio Interface.

• Three-way Intercom from turntable control console to tip of fly section and to pump panel control station.

• 110 or 220 AC Lights at Tip of Fly / and Outlets

• Two extra 500 watt floodlights at the tip of the fly section and at the base of the first section.

• One remote nozzle control at the pump panel station connected to collector ring swivel. **

• Rung blue Lighting. **

• One (1) 4” quarter-turn valve for water system, air operated.

• Electric Outrigger Controls. **

• Special tools to include torque wrench, socket, Allen wrenches, 9/16” combination wrench, with a toolbox. **

• Egress at end of top fly section painted bright red.

• One limit switch to prevent accidental cab lifting, if needed.

• One indicating light provided on the turntable control console to indicate when the aerial is aligned with the ladder bed, and can be bedded. **

• Tip anchors, one on each side of the ladder. **

** those option are only available with new ladder.